- Real HD Glass Protection Screen Protector Shield
- 9H Hardness
- 0.4mm thickness
- Shatter Proof
- Easy installation
- Responsive Touch
- Oleophobic Coating
- Complete Transparency
- Perfect Adhesion
- Includes 1 Tempered Glass, 1 Alcohol Wipe, 1 Cleaning Cloth
Make sure your device is completely cool.
Install in a dust-free / clean environment
Be careful not to put fingerprint on the screen or the glass. (if dust is on the glass or the screen, you can try wrapping a scotch tape around your finger (adhesive side out) and remove the dust
Clean your devices' screen thoroughly so no dust or lint is present.
Begin cleaning by using the alcohol prep wipe. Then remove all moisture using the dry cloth. Make sure that the alcohol wipe and solution have dried out and the screen is free from oil / residue as it will affect the glass from adhering properly.
Hold onto the sides of the protector; peel the clear sheet off revealing the adhesive sides of the glass. Make sure not to touch the adhesive side of the protector.
Align the bottom(or top) of the glass with your display and lay down gently.
Make sure that the protector is aligned properly before continuing.
Gently press the center of the glass and slide your finger along the center of your device and the adhesive will spread out evenly.This is important to prevent air bubbles forming from the center.
Ensure that the adhesive adheres completely on to the screen of your device.
If any bubbles remain, you can use a soft lint-free cloth and push the bubble towards the edge of the glass. If there are lint and dust, repeat step 1.
If there are bubbles, you can also gently lift one corner (closest to the air bubble) and release so it tries to apply itself on the glass again. You may repeat this process until it evenly adheres on the glass. Make sure that there is no lint/residue gets it between.
Please note that the closer the bubble is to the center, the more you have to lift the corner.